Arjo malibu bath user manual

Auto-fill function Automatically fills the tub to pre-set levels so you may focus your attention on preparing and transferring your resident. Multiple levels of anti-scalding protection Three-fold protection to ensure consistent temperatures for the safety and comfort of your resident. Contamination control hour water flush feature helps with contamination control. Optional integrated disinfection system allows caregivers to conveniently disinfect the bath and any transfer devices thoroughly and efficiently.

If using the optional Air Spa feature, the disinfection system automatically cleans and dries its internal nozzles. Remove the plug a , loosen the screw b , remove the knob c 2.

Activate the filling 3. Remove the plug a loosen the screw b and remove the knob c. Activate fill. Turn the plastic part d counterclockwise until the correct temperature is measured.

Open the panel lid and remove the disinfec- tion bottle 2. Fill a graduated 50 ml cylinder with your used disinfection fluid. Turn the adjuster ring a , fully anti clock- wise 2. Unclip and remove the adjuster ring a 3.

Replace old valve c and spring d with new ones. Unscrew the hose connection and pull out the plastic insert e , replace the two o-rings f. Unscrew the shower strainer, replace the big o-ring g and the plastic valve h. Raise the system to its top position and re- move the panels.

Use nipples on each of the four legs a to lubricate. Check the Safety Cut- out Switch When something comes between the lift arm and the tub during lowering, the lift actuator will lift itself a and release the safety-cut switch b. The lowering stops immediately but it is still possible to raise the lift arm. Check the Earth Wiring Connections The potential equalization is done in order to make sure that all metal parts have the same electrical voltage potential. Difference in potential between accessible parts means that a current can be lead through a person with risk of injury.

Potential equalization connector on chas- sis foot end 2. Chassis lift-end both movable a and fixed part b 3. The bath must have been connected to the mains prior to the test allowing the batteries to charge fully.

With mains on - push and release the stop button a a few times to be sure the tub func- tions are interrupted. Use safety catch kit. Safety catch removal: 1. Remove the plastic plugs a 2. Use the ArjoHuntleigh load test equipment and refer to SP for general information on load testing. NOTE Do not make adjustments to exceed the above limits 1. Check Actuator Lifetime There is a built in counter for the lift arm actu- ator showing the number of strokes performed.

The counter can be reset with switch SW2 b. NOTE The castors must be properly cleaned according to the customer obligations before starting. Lie the product down onto a flat surface. Protect areas in contact with the ground so as avoid damage to sensitive components. NOTE All castors must be of the same brand. Replace Safety Belt Old version: The safety belt is replaced by unscrewing the two slide buttons a on the chair back frame.

Be sure to fit the belt parts b in correct position and tighten the two slide buttons firmly by hand. Replace Filter Air- blower 1. Malibu and Sovereign each feature an integrated transfer chair, enabling you to make the benefits of bathing available to a broad spectrum of residents while reducing the number of transfers required.

Malibu and Sovereign are also compatible with a wide range of Arjo transfer aids and hygiene lifters. This provides comprehensive coverage for the transfer, toileting and bathing of residents in the A to C mobility spectrum. Work efficiently and confidently Fully height adjustable, both Malibu and Sovereign enable you to position the bath as well as your resident at your preferred working height, which can significantly reduce the risk of static overload.

In addition, Sovereign features a contoured base is designed for residents with reduced torso strength by providing added support for the thighs and knees.